Bad Dog

While I’m not set up, I was able to break ground and adjust the tail for Aaric. Claws next

Sorting thru patterns will take a sec there’s about 2000 pieces to go thru!

set up several shelves today! Working on clearing up the basement area into functional storage for ongoing projects. Getting about 1000 yards of Lycra stored took a lot

Setup is not a fast process and for the main work room where the minky is I’ll prob move most of the stuff on those shelves as I still have shelves to set up. 3D printing area has a lot to go. Honestly everywhere does, but working rlly hard to get things where they gotta be

Lots of fur to shelf still but it’s happening

Working on the fur! Still not quite halfway

Starting to block out where the desks will go. Still a lot to move in

All the fur is moved over (NOT sorted), all commissions in progress moved over. Still have a lot of other things to move before I can begin setup

Big moving day today! Juki, embroidery machine, about half the fur are moved over. Still have a decent bit of shelves, desk, and ton of fur to move. It’ll take time to set everything up properly!

been repainting new spot. The sump drain is completely clogged, utilities r on, tmr is the start of the second uhaul to move the shop. I have to replace the pressure regulator valve for the water heater. Finally got utilities on. Moved all the 3D printers, printers, dye sub, and fursuit heads today

Unloading the storage assets today

Unloaded the storage assets that weren’t stolen. Still must unload them. Today was a huge work day

Moving has begun! It will take a 3 weeks not including finishing setup.

Heads up- have to very suddenly move. It’ll be a few weeks before it begins. Working on packing down the shop but it’s not a fast process esp w this health condition. I will likely get surgery when the heavy lifting is done