Electrical Engg. By Ashish sir
Open in Telegram
1 942
Subscribers
+224 hours
+27 days
+630 days
Posts Archive
41. The major content of coal in India is ________________.
a. Dust b. Ash c. Fly ash d. Cinder
40.The coal with highest ash content is ________.
a. Lignite b. Steam coal c. Coking coal d. Bituminous coal
39. What is the superior quality of coal called?
a. Anthracite b. Coke c. Bituminous d. Peat
38. Name the system that is mainly employed for the disposal of fly ash.
a. Pneumatic b. Hydraulic c. Both (a) & (b) d. Steam jet system
37. The best coal suitable for the production of energy is_________________.
a. Lignite b. Bituminous c. Anthracite d. Peat
36. Evaporative type of condenser has
a. Water in pipes surrounded by steam outside. b. Steam and cooling water mixed to give the condensate. c. Steam in pipes surrounded by water. d. None of the above.
35. Spray ponds are used to cool the warm water coming from the condenser in ________.
a. Large power plants b. Small power plants c. Medium power plants d. Both medium and large power plants.
34.What is use of the air pumps in the condenser?
a. Remove water b. Air leaking in the condenser and to maintain the vacuum c. Maintain atmospheric pressure and the condenser d. Both (a) & (b)
33.Water used in the steam plant is used for cooling in_______________.
a. Condenser b. Turbine only c. Boiler tube d. Boiler tubes and turbines
32. A condenser condenses the steam coming out from___________.
a. Boiler b. Turbine c. Economiser d. Super heater
31. The draught produced by the chimney is________________.
a. Forced draught b. Natural draught c. Induced draught d. Balanced draught
30.Air- preheater in a steam power plant_____________.
a. Recovers the heat from the flue gases leaving the economiser. b. Improves combustion rate. c. Raises the temperature of the furnace gases. d. All of these.
29.The use of air preheater increase the temp of the air by about______________.
a. 50° b. 20° c. 5° d. 30°
28. The reheat factor in a steam turbine depends on
a. Stage efficiency. b. Initial pressure and temperature. c. Exit pressure. d. All of the above.
27. The governing principle of steam turbines are ________________.
a. Nozzle control governing b. Throttle governing c. Bypass governing d. All of these
26. The pipes carrying the steam are made of _________.
a. Steel b. Cast iron c. Aluminium d. Cobalt
25. A steam turbine with no nozzle is ________________.
a. Reaction turbine b. Impulse turbine c. Both (a) and (b) d. None of these
24. Turbo alternators run at speeds
a. Constant speed of 3000 rpm. b. Constant speed of 1000 rpm. c. A variable speed of above 1000 rpm. d. None of the above
23.The state of discharge of a lead-acid cell is determined by
A. e.m.f. of the cell B. specific gravity of the electrolyte C. colour of plates of the cell D. none of these E. all of these
22.The reluctance of a magnetic circuit depends upon
A. current in the coil B. number of turns of the coil C. flux density in the circuit D. none of these E. voltage in the coil
