ATS CLASSES

Q.16 Hole dimensions is 50.00±0.02 mm and shaft dimension is 50.00(-0.01,-0.03 mm) . The fit is

Q.15 Clinometer is an instrument concerned with

Q.14 The two slip gauges in precision measurement are joined by

Q.13 A ring gauge is used to measure

Q.12 Which one of these instruments is a comparator

Q.11 Sine bars inherently become increasingly impractical and accurate as the angle exceeds

Q.10 Least count of Vernier caliper is

Q.9 The maximum amount by which the result differs from the true value is called

Q.8 In hole basis system , the basis hole is one

Q.7 In Clearance fit,

Q.6 Ring and gao gauges are used to check the

Q.5 The following limits are specified in a limit system. To give a clearance fit between a hole and a shaft Hole 25±(0.02,0.1) , Shaft 25 ( -0.04 mm, -0.02 mm) Determine tolerance on shaft

Q.4 The plug gauge ís used to

Q.3 Standardization deals with the characteristics of product that include

Q.2 What is the full form of CMM

Q.1 Feeler gauge is used for

Q . How many of u revised Metrology notes and lectures for tomorrow test?

Q. Now Welding syllabus is also completed next subject Will be start Industrial Management. Did you watch and make notes of all lectures of welding ?