ASHCHARYA BANSAL
Kanalga Telegramβda oβtish
POSITIVE TALKS π Ex.IESπ| Ex.NTPCπ|B.Tech & M.Tech(Mech)π₯|Educator π¨π½βπ«| Josh Talk SpeakerποΈ| Investor/Trader π |Motivational SpeakerποΈ| Theist β¨9205326638 Donβt click on link for payment if anyone will ask in my name (some scammers are using my name)
Ko'proq ko'rsatish9 054
Obunachilar
+324 soatlar
+857 kunlar
+2930 kunlar
Postlar arxiv
9 053
CMRL_IIT_Madras_Employment_Notification_No_CMRL_HR_CON_10_2024_dated.pdf4.60 KB
9 053
Ok. For me it was an online interview.
- The interview has all the program coordinators of each M.Tech. branch i guess. (I Couldn't see them as thier camera was off).
- HOD started the talk and asked briefly about me and all.
- Then according to the the option priority HOS asked the Program coordinator (PC) concerned to ask questions.
- After the first PC, it is followed byvthe other PCs. And they ask basic questions pertaining to the corresponding branch.
- In my case I think PC s from my first 2 branch choice branch asked asked.
- They check whether we know the basic fundamentals of that corresponding M.Tech. stream.
- I think I got a question of unit of thermal diffusivity and all.
9 053
BALIVADA MAHIDHAR
Panel No 2
Duration 35 min
Fav subj: BTD, HT, FM, RAC
First and second law of thermodynamics
What are ways to improve efficiency of rankine cycle
What is efficiency of rankine cycle
How much pressure you maintain in condensor
What are boiler mountings?? Tell me some boiler mountings?( I'm missing one imp boiler mounting) so they asked me if this mounting is not there you don't even start boiler.. Think?
How do u measure flow rate in pipe if the pressure loss is already known??
What is hydrodynamically smooth and rough pipe??
What is difference between welding, soldering and brazing?
Is the base metal heated during brazing??
Design a pipe which was supported on two ends what kind of loadings do u consider?? ( on board)
They again came to manufacturing
Different kind of manufacturing processes
How do you manufacture small dia pipes?
Difference between shaping and planing ?
What are ideal properties of coolant??
Can we use petrol as coolant?
In general ductile material have which grain structure and brittle material have which grain structure??
Explain how fine grain ductile and coarse grain brittle.?
Consider a butt joint which plane of cross section has weak in strength?
Given Cantilever with udl how do u find deflection??
Derive heat conduction equation in cylinder coordinates (considered some assumptions and derived).
