AFS CHANNEL

Laptop : Dell N4030 DJ1 Capella UMA MB 10212-1 Problem : No Power DC Ampere Load : 0.001 After Check 19V VIN OK VREG 3 and VREG 5 OK But Enable is Not Coming So Check Near IO there no 3V present at any component So check in schematic there is found 0 Ohms Resistor who passes 3V LDO to KBC PWR but can't find position in board so i requested boardview in group and downloaded it and found resistor position But resistor Not present in board and also written DY in schematic but i tried adding them then ampere increased to 0.024 and some little bit heating produces nearby standby and io so i removed it then i search for KBC PWR then i found another source of LDO who creates KBC PWR found 3V Present on gate of q3704 P Channel JFET which should not be present to make KBC Power and Properly Analyzed then found the game changer is AC_IN#_KBC But its track Connected to IO Board then found some dry solders and some rust on connector between main board and io board then i removed the connector and clean the rust and found some tracks damaged then re solder the connector and make 2 jumpers then check but it give some fluctuations then i recheck the connector while connecting. then found the upper side of the connector which is connected to daughter board the one side is totally swinging and detatched from the soldering by flexible force of the board. then also resolder it and fit then check my problem has been solved.Power and Display also Come. Always happy with the support of rafi sir, Thank You.

💥💥AJAY——->AFS FAMILY MEMBER💥💥 💥💥SMALL CASE STUDY.....NOT FOR EXPERTS.💥💥 MOTHER BOARD: LA-G07DP.. TROBLEM: NOT TRIGGERING. STEPS: CHECKED COIL IMPIDENCE.........ALL GOOD. DC JACK LIGHT GLOW OK: ........CONFORMED +3VLP(LDO3) OK. CHECKED...._3V ALW AND 5V ALW........NOT GENERATED. HERE EC ON IS USED FOR GENERATE THIS VOLTAGE. 5V_3V_EN....FROM IO NOT GENERATED. CHECKED IMPIDENCE AT THAT POINT........LOOKING GOOD. STARTED CHECKING IO REQUIMENTS. VCC_LPC,VCC,AVCC.......OK EC_RST......OK LID#.......OK ADP_ID.......OK ACIN...OK RTC...SECTION...LOOKING GOOD.TRIED WITH ANOTHER CRYSTEL.....NO CHANGE). FLASHED EC BIOS.......BUT NO EC_ON. BEFORE CHANGING IO.... APPLIED 3V FROM RTC CELL ....AT 5V_3V EN PIN. CHECKED....COILS 3V ALW AND 5V ALW GENERATED...ALSO TRIGGERED. DC READING 500 RANGE. LATER...I USED 10K RESISTOR.....,TOOK 3V FROM LDO 3V. FOR SAFTY PURPOSE...CUT TRACK EC_ON LINE NEAR IO SIDE. TESTED LAPTOP 3HR....GOOD. 10K RESISTOR+ AFS KNOWLEDGE= 1K IN POCKET. THANKS....RAFI SIR,FOR KNOWLEDGE AND MOTIVATION. ❤️❤️❤️❤️

💥 If anyone need thermal imaging camera, you can contact syed LATIF +919325581281.

💥 Bad news, this baby girl expired after operation, INNA LILLAHI WA INNA ILAIHI RAJIOON

💥 Phonepay, google pay no

6305700801

Today very urgent....in admitted in hospital.....for the surgery.... around cost 2000000/-

Assalamu alaikum wa rahmatullahi wa barakatuh Rafi sir... Permission I'm send this in our group......