IGNITE Electrical & Electronics

The total resistance in a parallel circuit is always ______ the smallest resistance of any of the individual resistors.

What is the relationship between current, voltage, and resistance in a series circuit?

What is the unit of electrical power?

Which of the following materials is a good conductor of electricity?

According to the Economic Survey Report 2024-25, what is the percentage share of solar energy in Maharashtra's production?

When will the Women's National Boxing Championship 2025 be held?

According to the Economic Survey Report 2024-25, what was the growth rate of Maharashtra's overall economy in 2023-24?

According to the Economic Survey Report 2024-25, which district in the state of Maharashtra has the highest per capita income?

According to the Economic Survey Report 2024-25, what percentage growth rate of Maharashtra's agriculture sector has been estimated to be?

When designing a machine with moving parts, the most important factor for minimizing friction is:

What is the most common reason for machine components like gears to fail due to wear?

When designing a shaft, which of the following factors is most critical for preventing failure under torsional loads?

Discontinuity in geometry causes stress concentration in machine components. Which of the following is NOT a method of alleviating stress concentration at the corner of a stepped shaft?

Crowning of a pulley is done to

The area under the load curve represents _______

A power system has a maximum load of 15 MW. Annual load factor is 50%. The reserve capacity of plant is _____ if the plant capacity factor is 40%.

A protection system engineer is planning to provide the complete protection, he can achieve this by ______

The given graph is the depiction of ________ on a large power system network.